Q:How to install the sensors?
A:Install the 3-pin connector of sensor on the main control unit.

Q:How can I share my code with other device?
A:Click the“Share”button in the "Code" interface.
Click "Share" or  "Take" to continue.
Scan the QR code to complete sharing.
Note: This function requires the two devices to connect to same WIFI.

Q:Can the robot run the code offline (without tablet or smart phone)?

Click the "Upload" button in the "Code" interface to upload your code to the robot.

Turn off the power of the main control unit. Then press and hold the power button for 5 seconds to turn it on. The robot will start offline mode and run the code automatically according to the uploaded code.